What Mounting Hardware Is Included With L11 Disconnect Switches, Sizes 30 To 60 Amps?
Are there replacement parts for hardware bags supplied with L11-C30-1753, L11-J30-1753, L11-N30-1753, L11-J60-1753, L11-J60-1753, L11-N60-1753 disconnect switches? Are there part numbers available for sale to order the mounting screws, the shaft set screw and the shaft clip or hair pin components included in the hardware bag supplied with these switches?
These switches are shipped with a hardware bag containing the following components:
- 30A switches = (1) M4 x .7 set screw (8 mm long), (1) shaft clip and (2) M4 x .7 mounting screws (22 mm long). The replacement hardware bag part number is L11-30-HDWR which contains all the components listed above.
- 60A switches = (1) M4 x .7 set screw (8 mm long), (1) shaft clip and (4) M4 x .7 mounting screws (22 mm long). The replacement hardware bag part number is L11-60-HDWR which contains all the components listed above.
Note - The L11-60-HDWR replacement part number (the one that comes with the 4 mounting screws + 1 shaft set screw + 1 shaft hairpin because) can be used on either the 30 or 60A devices (you will just have 2 extra mounting screws for the 30A switches). Components in kit L11-30-HDWR are shown below.
Note - the shaft clip (hairpin) in these hardware bags is smaller than the obsoleted L10 30/60A shaft clips (hairpins). These two "hairpins" are not interchangeable.
For additional information please contact your nearest authorized distributor, sales representative, or call our customer service or technical support lines.